How Cooling Tower Water Distribution Works: Nozzles and Sprayers
Fill can only cool the water that reaches it. How crossflow and counterflow towers distribute water, why nozzles fail, and what to check when replacing them.

A cooling tower can only cool the water that reaches its fill. If water lands unevenly, some of the fill runs dry while other areas flood, and the tower loses capacity even when the fill itself is in good shape. The water distribution system and its nozzles are what prevent that.
Crossflow towers: gravity basins
In a crossflow tower, hot water is pumped into open basins on top of the tower. It drains by gravity through nozzles set into the basin floor and falls onto the fill below. Each nozzle breaks the stream into a spray pattern that covers its share of the fill. Our Spiral Target nozzle uses a spiral target under the orifice to spread water evenly.
Counterflow towers: pressurized spray
In a counterflow tower, water is pumped through a network of pipes, or headers, above the fill. Spray nozzles on the headers throw water in a wide pattern across the full plan area of the cell. The PPI Sprayer is a French-type spray nozzle designed for this job.
Signs of a distribution problem
- Dry spots or streaks on top of the fill
- Basins that overflow or run unevenly
- Nozzles that are cracked, clogged, loose or missing
- A mix of nozzle types or sizes left over from past repairs
When to replace nozzles
The best time is during a fill replacement, when the distribution system is already exposed. New fill under worn nozzles can't deliver full performance. Match the orifice size to the design flow per nozzle (or header pressure, for spray systems) so the water load stays even.
Need help sizing nozzles for your tower? Request a quote with your flow and basin or header layout.